HOME | DD

Description
A 3D print of my Jackal Enchantress. I used a darker filament and a finer printing resolution. I think it came out really good. Sadly her staff was damaged during the printing process. Its wings were a little too thin and they fell over. I thought about trying to show her face and body markings by having them be bumps, but I wasn't sure if they would be visible and it would be difficult to set up. I printed the body and head separately and then snapped the head on to the body.

The model is approximately 94mm tall and too 9 hours and 25 minutes to print on an Ender-3 printer.

Description
A 3D print of my Jackal Enchantress. I used a darker filament and a finer printing resolution. I think it came out really good. Sadly her staff was damaged during the printing process. Its wings were a little too thin and they fell over. I thought about trying to show her face and body markings by having them be bumps, but I wasn't sure if they would be visible and it would be difficult to set up. I printed the body and head separately and then snapped the head on to the body.

The model is approximately 94mm tall and too 9 hours and 25 minutes to print on an Ender-3 printer.