HOME
|
DD
All
Tag
Groups
Search!
johnmiic
— Endeavor Cardboard Model DSC01756 copy
#micronauts
#endeavor
Published:
2023-09-23 14:00:01 +0000 UTC
; Views:
85
; Favourites:
0
; Downloads:
0
Redirect to original
Description
At this point I had not yet worked out how to get the Engine Pylons to look comic-book accurate. The simplest explanation is you measure from the Outboard Sides. You start at the round Cone Hull by the top ring and extend your Outboard Side Walls down to the Engine Pod. The Inboard Side Wall also starts from the curve of the ring. The undersides of the Engines start from the larger Cone Hull. It would be easiest when the top ring is already in place. As long as you start each Pylon from the ring and extend it outward to the pods you can have straight, flat-top, parallel engines. You might have to sub-duct the Inboard Wall under the Top Deck but it should work.
Related content
johnmiic - Endeavor Cardboard Models Dsc01916s
johnmiic - Endeavor Cardboard Model DSC01772 copy
johnmiic - Endeavor Cardboard Model DSC01714 copy
johnmiic - Endeavor Cardboard Model DSC01701 copy
johnmiic - Endeavor Cardboard Models DSC01917S copy
johnmiic - Endeavor Cardboard Model DSC01737 copy
johnmiic - Endeavor Cardboard Model DSC01731 copy
johnmiic - Endeavor Cardboard Models DSC01895S copy
johnmiic - Endeavor Cardboard Models DSC01893S Copy
SolarLiger - Landing pad/battle stadium
vorennaal - Studio scale AT-ST (WIP)
Ohnhai - Falcon Wip back plate
Rocketmodels - Kitbash project begins
Shadowowl129 - Deep Space 9 2
angela808 - Fossil Extraction
Frostrubin - USS Virgil 19
squarenuts - Tanks up close
nyankodevice - SDF-1 Macross (11)
Comments:
0