HOME | DD

Description
I had an idea to nest a spirograph inside a spirograph, and the idea went from there. This is simply the colored version.

Repeating Spirograph 1-1: [link]

I used a ruler. I measured off 8 inches on each side, then made hash marks at each quarter inch. From there, I connected the point in the top left corner to the first hash mark in from the left on the bottom (or one off from where directly opposite would be). I went one hash mark below the one in the top left and connected it to the one to the right of the first line on the bottom (aka: two hash marks in from the left on the bottom), intersecting the first line. All the lines intersect. That's how I created the outer pattern, then I customized it for the internal spirographs, but followed the same logic. After all that was done I colored in the black fields.

Description
I had an idea to nest a spirograph inside a spirograph, and the idea went from there. This is simply the colored version.

Repeating Spirograph 1-1: [link]

I used a ruler. I measured off 8 inches on each side, then made hash marks at each quarter inch. From there, I connected the point in the top left corner to the first hash mark in from the left on the bottom (or one off from where directly opposite would be). I went one hash mark below the one in the top left and connected it to the one to the right of the first line on the bottom (aka: two hash marks in from the left on the bottom), intersecting the first line. All the lines intersect. That's how I created the outer pattern, then I customized it for the internal spirographs, but followed the same logic. After all that was done I colored in the black fields.