HOME | DD
marshon — Predator Bio Finished
Published: 2011-03-08 19:11:42 +0000 UTC; Views: 1962; Favourites: 21; Downloads: 284
Redirect to original
Description
The mask completed with a half back and the dreads addedRelated content
Comments: 23
Foam cylinders known as 'backer rods'
👍: 0 ⏩: 1
okay how long did it take you to make it?
👍: 0 ⏩: 1
Oh I dunno, I tend to work on thing on and off as the mood takes me. Probably a couple of months from start to finish
👍: 0 ⏩: 1
okay the reason I'm asking because I'm trying to make the mask myself and I wanted professional opinion and suggestions that they did to make it themselves no offense
👍: 0 ⏩: 1
No offence taken
I don't usually have to work to deadlines very often so things get a few hours on them here and a few hours there. It makes it a bit difficult to judge actual time taken. Allowing for drying times I think you could make one in a week if you could give it your full attention.
👍: 0 ⏩: 1
okay thnx if you have more advice I'm more than willing to listen to and take notes on it.
👍: 0 ⏩: 1
Very cool. How did you make the dreds?
👍: 0 ⏩: 1
They are made from round insulation foam known as 'Backer Rod' coated in black latex.
👍: 0 ⏩: 1
Looks really good! I really like the paintup you've done on the mask -- it really has that metallic look to it.
👍: 0 ⏩: 1
Thanks, hopefully I'll get around to sticking it on a naked girl and then painting her as a female Pred.
👍: 0 ⏩: 0
It's glass fibre resin over a card armature. This is then covered in car body filler and sanded back.
👍: 0 ⏩: 1
Quite similar to the way I make the busts for my leather casts. Though I generally use Clay Creat for any volume to reduce weight.
Nice work.
👍: 0 ⏩: 0
This looks stunning! They could of used this in the movies. Looks very professional. I am jealous!
👍: 0 ⏩: 1