Comments: 8
ScarletWarmth [2010-09-14 22:31:53 +0000 UTC]
Great work station. The perspective is very good. I do love that you constructed the office credenza with countertops made out of faux finish marble.
I agree with *Miarath . They might would drop and unstable. And I was concern that I think these look like little bit high for you. Maybe remove the glass blocks. The two monitors should be at your eye level in straight line otherwise you neck might be bit strained/stress causing headache. Sorry, just my advice or its up to you. Just my concern.
(I hope doesn't sounds like motherly advice hehe)
Great work btw. I havent recently used with AutoDesk in ages. It brings back my memories. Thank you for sharing.
👍: 0 ⏩: 2
Royce-Barber In reply to ScarletWarmth [2010-09-15 06:54:26 +0000 UTC]
Thank you awesome buddy!
The reason I chose Laminate countertop, is that it's very lightweight to lift, in comparison with marble, corian, granite, etc. The laminate has a stone look but also costs much less. I could have easily installed granite, but I enjoy the lighter weight materials being portable, so I can take apart my office at any time. Also... I've installed granite countertop in kitchens... It's a lot of work, and it can be dangerous if it breaks in half.
The office is pretty sturdy, and the 24inch monitors are very heavy thus they don't move around, but yeah I am concerned about people pushing the board off the glass blocks. I'll glue the blocks, but also I might make indentations for the blocks to sit into. I might need a thicker board. The board right now isn't very thick, because all the weight is on the glass blocks on both sides, and no weight is in the middle.
As for ergonomics, my eye level is near the top of the monitor, where it should be as far as I know. The image isn't to scale, I need to redo the whole thing with correct measurements. Thank you for thinking about my health.
👍: 0 ⏩: 0
Miarath [2010-09-14 18:46:09 +0000 UTC]
Hmm, looks pretty neat, but how do you keep the board in place for the monitors? I'd be afraid that something would drop or so.
👍: 0 ⏩: 1
Royce-Barber In reply to Miarath [2010-09-15 06:46:17 +0000 UTC]
You're absolutely correct, it's a concern for me too. The glass blocks are very sturdy and deep, but anything can happen. I might silicon caulk (glue) the glass blocks to the underside of the board. As for the monitors, they fit snugly into the inset circles in the board. I have a slab of granite I want to carve up, but I don't know what tools to use. My Dremmel Rotary Tool (drill) may not be strong enough to carve stone.
👍: 0 ⏩: 1
Miarath In reply to Royce-Barber [2010-09-15 07:12:03 +0000 UTC]
Well, I think you definitely should glue the blocks to the board, just to be sure.
Hmm, your're could be right, cause I don't think it's made for stone but they might have a fitting tool for it or something. Sounds like a lot of work in front of you, too.
👍: 0 ⏩: 1