Comments: 25
unitoone [2012-12-07 00:44:26 +0000 UTC]
I'm crying right now... this is beautiful. *sniff*
👍: 0 ⏩: 1
EROCKERTORRES In reply to GrimCW [2012-12-05 15:06:01 +0000 UTC]
Lol it could be bigger too but then it'd be really expensive. This one is already $36
👍: 0 ⏩: 0
matty4z [2012-12-05 12:42:23 +0000 UTC]
if it didnt cost $1000-ruffly id get 1 of them printers this is tops
👍: 0 ⏩: 1
EROCKERTORRES In reply to matty4z [2012-12-05 15:03:57 +0000 UTC]
You can build your own. Theres websites that explain how and its relatively simple and cheap.
👍: 0 ⏩: 1
EROCKERTORRES In reply to matty4z [2012-12-06 16:12:08 +0000 UTC]
Cost im unsure of sknce I haven't done all the research yet but google "repap 3d printer" and should be the first selection.
👍: 0 ⏩: 0
Ardail [2012-12-05 05:57:57 +0000 UTC]
That's a good 3-d printer
👍: 0 ⏩: 1
EROCKERTORRES In reply to Ardail [2012-12-05 06:02:44 +0000 UTC]
Its a company based out of New York that prints off peoples designs professionally.
👍: 0 ⏩: 1
Ardail In reply to EROCKERTORRES [2012-12-05 07:19:00 +0000 UTC]
Oh that makes sense. I mean I did a 3D printed protoss emblem. But it didn't loo nearly that smooth for all the printing layers
👍: 0 ⏩: 1
EROCKERTORRES In reply to Ardail [2012-12-05 07:21:59 +0000 UTC]
I actually want to try and make my own 3D printer if I can
👍: 0 ⏩: 1
EROCKERTORRES In reply to Ardail [2012-12-06 03:26:02 +0000 UTC]
Lol it is something where you need to progress carefully
👍: 0 ⏩: 1
Ardail In reply to EROCKERTORRES [2012-12-06 04:03:43 +0000 UTC]
pretty much, and be very careful about it
👍: 0 ⏩: 1
EROCKERTORRES In reply to Animegirl1337 [2012-12-05 02:30:24 +0000 UTC]
I'd say thanks but I didn't make it lol. made the 3D model and has them printed and shipped out through Shapeways
👍: 0 ⏩: 0