Comments: 6
erolyntigerdragon In reply to Twerpa [2009-09-29 00:14:28 +0000 UTC]
Which legs don't have joints?? o.O
Are you talking about the ankles??
The ankles were tricky, I tried to make it so that the weight would lay on where the point of the lower legs hits the hooves. Just remember though, this beasty wouldn't weigh much seeing as it's about as tall as an embroidery needle so weight isn't a huge problem. I had to make that a point though because the hooves need to pivot.
Other than that, I though I covered all of the joints...
👍: 0 ⏩: 1
Twerpa In reply to erolyntigerdragon [2009-09-29 23:14:57 +0000 UTC]
Maybe it's just how I looked at it at first. xD But now that you mention it, I see what you mean. I didn't think of how small it was until you mentioned the needle.
Oh, and I don't think I'm gonna be able to go to Rmcad with you. D: It's way to expensive. =/
👍: 0 ⏩: 1
erolyntigerdragon In reply to Twerpa [2009-09-30 18:40:57 +0000 UTC]
oh no!! :'( Sad day!! Even with student aid and whatnot it's too expensive??
👍: 0 ⏩: 0
SkyJaguar [2009-09-28 06:01:58 +0000 UTC]
This is very well-done! Kind of spooky, though.
👍: 0 ⏩: 1