Comments: 20
redxbacon [2014-08-03 02:20:55 +0000 UTC]
what are these made out of?
👍: 0 ⏩: 1
skynetbeta In reply to redxbacon [2014-08-05 01:15:40 +0000 UTC]
ABS Plastic Painted in a enamel lacquer.
👍: 0 ⏩: 0
Llama-lady [2013-10-11 14:07:33 +0000 UTC]
Thanks for sending me one of these in the trade package. Might make it into a pin.
👍: 0 ⏩: 1
Llama-lady In reply to skynetbeta [2013-10-14 18:09:04 +0000 UTC]
BTW, email me again at some point.
👍: 0 ⏩: 1
Kayian [2013-08-22 20:55:35 +0000 UTC]
I need this to fit into the center part of my book
It's in my gallery if ya want to see
👍: 0 ⏩: 1
skynetbeta In reply to Kayian [2013-08-22 21:04:28 +0000 UTC]
I sent you a note addressing the above
👍: 0 ⏩: 0
credechica4 [2013-08-22 18:20:19 +0000 UTC]
ive actually been thinking about making a leatherbound replica of the book myself if you can how much could you make one for me? if the dimentions were 10 inches tall by 6 inches and is this made of brass?
👍: 0 ⏩: 1
skynetbeta In reply to credechica4 [2013-08-22 20:58:06 +0000 UTC]
I am not sure as to what the price would be though it would be on the expensive side.
The head pictured above is made of ABS plastic however the one I would use for the book would be cast out of brass.
I would also cast custom brass hardware for the corners and spine of the book.
👍: 0 ⏩: 1
credechica4 In reply to skynetbeta [2013-08-22 21:12:53 +0000 UTC]
yeah how much would all the brass parts cost?
👍: 0 ⏩: 1
skynetbeta In reply to credechica4 [2013-08-22 22:48:41 +0000 UTC]
I wont know untill I start work on them as I have yet to determine the casting method best for these components.
👍: 0 ⏩: 1
credechica4 In reply to skynetbeta [2013-08-22 23:15:32 +0000 UTC]
ok when u get the price let me know?
👍: 0 ⏩: 1