Comments: 5
deepincision [2015-06-12 13:09:33 +0000 UTC]
Very impressive, I've seen a few people pull of Loki's helmet off very well and always wondered how to make those horns so thin yet self-supporting. Had no idea paper could do it! Good luck with the fiberglass though, from far away it looks smooth but close up you can see the individual paper panels, will it still sand smooth after it all cures? Hope it works!
👍: 0 ⏩: 1
HekateLesedi In reply to deepincision [2015-06-13 05:34:10 +0000 UTC]
On its own, no it won't sand smooth on its own. It will need several additional steps for it to be con-ready.
Once I've layered it enough both inside and out, I'm going to Rondo the inside to give it additional support. After that, I'm going to sand the edges a little and then use Bondo to fill it in and smooth it out. Then it's on to sanding and adding in detail work.
👍: 0 ⏩: 0
Rosewolf86 [2015-06-11 13:44:49 +0000 UTC]
Awesome!
👍: 0 ⏩: 1
HekateLesedi In reply to Rosewolf86 [2015-06-11 14:25:38 +0000 UTC]
Thanks. There's still a lot of work to do on it (support with fiberglass on the inside, for instance). But once I get to the finishing touches, this is going to look awesome!
👍: 0 ⏩: 1